3answers

[Components] Looking for any good yet cheap sunlight/ambient light sensors, but only found one, any suggestions?

I am looking for any good yet cheap sunlight/ambient light sensors, but I can only find one, does anyone have any suggestions?
1answers

[Components] Fabrication des BOBINES

Bonjour,sur le pcb principal deBITX 9 comment sont fabriqués les bobines L1,L2,L3?quel modele de tore,fil,nombre de tours SVPmerci73'
1answers

[Components] DIY Emergency Light

Trying to build the emergency light. Could you please give me the value for the trim pot you used and the zenner diode. and also the component list says 5R 2W for the 2 watt resistor however the mark...
2answers

[Components] What strategies are recommended?

What power management strategies are recommended for optimizing the 5CGXFC9E6F35I7N design?
1answers

[Components] Hi do you need to harvest MBC3/5 from an old cartridge for this flash cart to work?

Hi do you need to harvest MBC3/5 from an old cartridge for this flash cart to work?
1answers

[Components] Component version

I'm interesed in ordering the Wandy Amaury Dual ESP32-C6 gateway PCB Proyect board, but i would need the ESP32 to be the WROOM-1U version instead of the WROOM-1
2answers

[Components] capacitors question

in electronic circuit Coupling capacitors are used in series to allow only high-frequency signals to pass to the system load, as in the following image. Decoupling capacitors, also known as bypass cap...
3answers

[Components] Question In-Ears headphones

In-Ears headphones use magnetic dynamic drivers. If you bring the in-ears close to an electronic device that releases magnetism with a 29" CRT TV (coils, speaker) turned on, will this TV cause demagne...
2answers

[Components] I have a question about part assembly

Hi, are you guy's able to install male and female NEMA 5-15P connectors into a mold injected part that is manufactured by pcbway? and if so, where would you source it from?(I sent a few pictures ...
1answers

[Components] Verification if you can Procure Certain USB-C Connector

I would like to ask if you will be able to procure one of the following USB-C connectors, as I want you to assemble them in a future project:https://www.digikey.com/en/products/detail/assmann-wsw-comp...
1 2 3
Ranking Name Answers
1 KhronoSound Audio 7
2 PCBWay Team 3
3 Engineer 1
4 Jon Summers 1
5 Sonic The Hedgehog 1
6 yumiya kaoru 1